Dent Fix Equipment - Hammerhead - Multi-Pull Dent Remover Welder 2 inch Air requirements: 8

Air requirements: 8

allowing you access to tools in the front as well as way back in the drawer

Frame: Powder coated ASME coded 20-gallon receiver tank · 3/16-inch base plate to reduce vibration · 16-gauge powder coated two-piece belt guard with 1/4-turn release for quick access to belts · Convenient lifting handle · 10-inch flat-free tires

for spraying light-bodied coatings all the way up to low-VOC striping paints

Next Generation Rapid-Response Pressure Control

Dent Fix Equipment - Hammerhead - Multi-Pull Dent Remover Welder 2 inch Air requirements: 8Product Details Instructions Parts Breakdown (Not Available) Replace your stud welder with our 110 volt DF 595ii HammerHead. Same great quality, same essential accessories that provides the technician with the means to higher productivity and better results. It's like having sticky fingers and being able to pull dent with your hand. Shrinking tip, Wiggle wire tip, 1 pound wiggle wire, shrink tip, 3 finger claw, slide hammer rod & weight, short pull